Vipower SmartDup VP-8220 Uživatelský manuál stáhnout pdf (Strana 16)

14 SmartDup IDE CD Duplicator User’s Guide

1. Set the Power Switch to CD Duplicator ON position.

The LEDs will display the firmware version number, for example:

and then run through a series of test numbers:

00, 22, 33... 88, 99.

2. When the self-test is completed, a “rd” (ready) is displayed, followed by two

beeps, “00”, then the speed/function setting or

3. Insert the CD-RW media in the bottom CD-RW writer.

4. The LED display will show and beep a final countdown, then display a rotation

pattern of LED indicators during the erasing process.

5. Upon completion, “00” is displayed, beeps are heard, and the CD-RW media

is ejected.

6. The Erase Only routine can be repeated by inserting another CD-RW media.

7. If a failure occurs during the Self-Test, Test, Erase, or Copy modes, beeps are

heard, then steady “Er” is displayed.

(4) Test & Copy (H4/L4)

Sets the CD-R/RW to “Test & Copy” mode. If you set SW4 to Low Speed, all

operation steps will be the same as High Speed, except the recording speed will drop

to 4X only.

Make sure the CD-R or CD-RW media is blank.

Test & Copy mode DIP switch settings: High Speed

Low Speed (4X)

1. Set the Power Switch to CD Duplicator ON position.

The LEDs will display the firmware version number, for example:

and then run through a series of test numbers:

00, 22, 33,... 88, 99.

2. When the self-test is completed, a “rd” (ready) is displayed, followed by two

beeps and then the speed/function setting or

3. Insert your CD title into the top CD-ROM drive and blank CD-R or

CD-RW media in the bottom CD-RW writer.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Žádné komentáře

Vipower SmartDup VP-8220 Uživatelský manuál Strana 16